Chicago-gaming Nicktoons Racing Bedienungsanleitung

Chicago Gaming Company, 4616 W. 19th Street, Cicero, IL 60804 (708)780-0070 Copyright © Chicago Gaming Company Page 1

Table 8, Adjustments & Calibration Dialog Box 5.1. 1ST Coinage for Game Play To start a game. This is the amount of X coins needed to add Y pl

temporarily stops the game to ask from more coins. Below is an example of the message “2ND COINAGE MESSAGE” if the amount of coins is non-zero. If

5.5. Attract Messages This is 2 lines of text, up to 35 characters for each line, to be displayed during the attract mode. Messages are limited to c

Table 10, Difficulty Percentage Description Percent Description 25% Minimum Very Easy 80% Easy 90% Medium 100% Hard 110% Very Hard 150% Maximum Ext

5.17. Windows button Press this button to Cancel any changes (adjustments, reset champion table, and calibration data) and exit the game to go to Wind

Press any of these buttons to re-calibrate the Steering Wheel, Accelerator Pedal, Brake Pedal, Forward/Reverse shifter. Instructions are provided to r

6. Trouble Shooting In case something happens to the software on the Hard Drive or other problems, a boot CD has been included to reload all software.

7. Watch Dog and the I/O board The I/O board contains solenoid drivers, audio amplifier, and a watch dog circuit (to reset the PC if the PC gets lock

Pressing Switch S2 (when watch dog is enabled) will start a PC reset (Green LED CR1 will fast blink) . Pressing Switch S3 will set the power on “wat

“system date” = {set the current date} “system time” = {set the current time} 8.1.1.1. Floppy Driver Floppy Drive A = Not installed Floppy Drive B =

Table of Contents 1. Safety Notices...

8.1.3.1. Power Restore on AC/Power Loss = Power On Ring-in Power on = Disabled PCI Device Power On = Disabled RTC Alarm Power On = Disabled 8.1.3.2.

9. MAIN WIRING SCHEMATIC: Copyright © Chicago Gaming Company Page 21

10. AC SCHEMATIC: Copyright © Chicago Gaming Company Page 22

1. Safety Notices The following safety instructions apply to all game operators. We recommend that you read this page before setting-up Nicktoons Ra

3.2. Game Background, The Races There are 12 different races 1st Cup Races 1) Reptar Raceway (The RugRats) 2) Dam Prix (The Angry Beavers) 3)

Table 1, Game Connector DB15 Pin Description (Pots are 100K ohms) Control Other Wire 1 Red +5V DC Main 5VDC 2 Brn Joystick A Button 1 Horn Swi

Reverse(and Forward) Switch & Mechanism, Handle is in Forward position. Switch is open for Forward, closed for Reverse 100K resistor is wired acr

4.3. DB9 Coin Counter/Switch on COM1 Serial port The Coin counter and coin switch are hooked up to COM1 Serial port via the Mother Board D815EFV / D81

0.011 PERSCALE:NoneCAD REF:DWGSIZECCHICAGO GAMING COMPANYPROJECT:DWN BY:DATE:QTY:REVISION If another motherboard is used with a DB9 or a DB25 connecto

Table 7, PC Power Supply Cable Pin Description 1, Red 5VDC 2, Blk Ground 3, Blk Ground Male Pins 4, Yel 12VDC 4.4. USB Dongle Always plug in t